What does WULI stand for?

Where u left it

Choosing the right Wuli Please note Wuli has been tested for vehicles up to 3 tonne Aggregate Trailer Mass.

STEP ONE Check the rim size

Wuli is suitable for vehicles that have a 14 inch and above rim. You can easily identify your rim size from the tyre. Yes, it’s that simple.

Your tyre wall has a range of information on it. The rim size is shown by a “R” with a number after it. So, if your tyre has R14 or a number greater than this Wuli will fit.

STEP TWO Brake size

Measure here to determine brake size

STEP Three Identify stud pattern

Measure from centre of stud to centre of stud

STEP TWO Brake size

If your vehicle has a braking system you will need to identify what size brakes are on board. For Wuli to be suitable the brake size must be 10 inches or less, this represents approximately 285 mm or less.

STEP Three Identify stud pattern

Most vehicles will have either a Ford/Holden 5 stud or Landcruiser/ Nissan Patrol 5 or 6 stud pattern. Wuli has a different component for each one. To help you identify which one your vehicle has refer to the diagram below. If your wheel has five studs and measures between 64mm – 68mm it is a Ford/ Holden stud. If the measurement is approximately 88 mm it is a Landcruiser/Nissan stud. If you have six studs and measures approximately 70 mm it is also a Landcruiser/Nissan stud. If you do not have a standard stud pattern Wuli is unlikely to fit.

STEP four Identify axle size

Your vehicle will require a square axle for Wuli to fit. Your axle size will be either a 40 mm, 45 mm or 50 mm. If you have an overlay axle, you will need to contact us directly and place a special order.